ssome

=http://www.chevrolet.com/contactus/
i sent a msg to them asking about a list of TSBs for this car.

http://theformulasource.com/modules....&id=3#question
136

Can I replace my 700R4 automatic tranny with a later model?
Yes. In fact, if your car was built prior to the 1987 model year, it's
probably a good idea (if you have the cash). In 1987 (and even on some of
the very-late-1986 cars), a number of improvements were made to the 700R4,
the most prominent of which was a change to the auxiliary valve body with
the main body and stronger components. This valve body is a section added in
conjunction with the full valve body that routes the fluid differently.
Earlier versions simply have a cover plate in place of this valve body where
a small amount of fluid reserve is kept for some operation. The newer model
has an accumulator to regulate the engagement of the forward clutch so that
the shift into "D" would be smoother. An abuse valve was added which, based
on throttle position, would short circuit the accumulator and cause the "D"
shift to occur faster (benefits apparent when rocking a car that's stuck in
snow or sand as it causes the clutch to engage faster to eliminate slippage
and heat built-up). These two items were also made applicable to the
engagement of the reverse clutch, thus smoothing its operation except during
"abusive" conditions.

The auxiliary valve body is on the drivers side, just behind the trans valve
body (opposite the accumulator housing). Four bolts hold the a 6 x 2 inch
block in place with a tube a tube connecting it to the front-side of the
main valve body. You can tell if you've got the auxiliary valve body without
pulling the pan. The later tranny has a slightly deeper pan to accommodate
the auxiliary valve body. To make certain identification, GM changed the
pattern of markings on the pan bottom where the magnet is located. These
markings are visible from the underside, near a rearward corner, forming a
square shape of size 1.75 inches or so. The later pans (accommodating the
auxiliary valve body) have unequal length lines (one set is longer than the
rest) unlike the earlier pans which have all lines equal length. Also,
behind the torque converter, look for a casting number on the front pump. If
the last three digits are "732", then you have the new, improved version of
the 700-R4.

The newer trannies also have a 10-vane pump instead of the old 7-vane pump
(more pressure results in quicker, firmer shifts and tranny longevity).

If do want to upgrade, you should check that the input and output shafts
will function with your existing converter and driveshaft. One of the other
upgrades for 1987 was the change of the input shaft from a 27 spline to a 30
spline. But keep in mind that there have been subsequent changes after 1987
as well. Your best bet is to use the most recent model you can find.

But, also remember that if you want the shift points to remain the same as
before, you should try to get one from a similar auto and engine since the
valve body springs and the governor are sometimes different for different
auto and engine combinations. In some cases the differences are subtle and
others not. The valve bodies on the early 700R4s are not interchangable with
the later models, so you do not have the option of simply swapping valve
bodies to get around this issue. Also, note that if the newer tranny has an
electronically controlled shift, it can be overridden.


i also saw a note that the manual xmission is a free fix.