Mombu the Chevrolet Forum sponsored links

Go Back   Mombu the Chevrolet Forum > Chevrolet > 87 Chevy Pickup 350 EFI "Blown ECM Fuse"
User Name
Password
REGISTER NOW! Mark Forums Read

sponsored links


Reply
 
1 13th August 18:36
ricks87chevy
External User
 
Posts: 1
Default 87 Chevy Pickup 350 EFI "Blown ECM Fuse"


Hi everyone, I'm new to the site. I came across it when trying to figure out
why my 87 chevy pickup 350 EFI,,,refuses to start. A member named Pode had
the same exact problem I was having. Here's what he said:
This motor normally starts with out a hitch. When I
tried to start the truck I got nothing, nada, zilch. I checked over
the fuses under the dash and found only one that was blown. It is
labled "ECM B". When I replace the 10 Amp fuse it instantly pops. I
can't recall hearing the fuel pump priming either. I did get the
engine to fire by pouring a little gas down the throttle body, but
immediatly dies. So at this point I know I am not getting fuel. So
what else could possibly be blown and or shorted out at this point?

In response to that, a member "Elliot" responded:

ECM-B is the computer's battery output to the fuel pump. Sounds
like you blew the computer. Pull out the computer and replace the
fuse. If it doesn't blow, measure the voltage on the socket (same
as the orange wire to the fuel pump relay. If the voltage is low,
measure the resistance from the ECMB fuse to ground (not sure which
side). If it isn't shorted to ground
you probably isolated the problem to the computer. If that's the case
you may have damaged the computer's PROMs too (hope not) - but
just in case, a J-yard replacement w/ chips seems the way to go (AZ
has them w/o chips).
If it is still shorted w/o the computer, pull the fuel pump relay,
and do it again. If it's still shorted (blowing fuses) try pulling
the Electronic Spark Module (ESM (a flat black box in the middle of
the fire wall with an hand full of wires to it)).
Elliott

Looks like Elliot knew what he was talking about from Pode's response:

I followed Elliotts instructions and he
was right. First I did test the ESC, and the fuel pump relay. All
were good. I then pulled the power on the fuel pump and the ECM-B
fuse would still blow when I replaced it. Last but not least, I
disconnected the Computer and BAM, no blown fuse. I picked up a new
ECM, move the PROMs and the damn thing fired up like it use to. Thanx
to you and the board members I save a a.s load of money.

Man!!! Wish I had Pode's luck. I've done the same thing to my truck, good
news is that by process of elimation, I too found that it was the ecm,,,,,
when I disconnected it, the fuse didn't blow. So, fuse blowing problem fixed,,
,,,,,,The bad news is, I purchased a new ecm, switched the PROMS and the
truck STILL won't start!!!! Now what??? ANY advice or suggestions, welcome!
Thanks,
Rick
  Reply With Quote


  sponsored links


2 13th August 18:36
snoman
External User
 
Posts: 1
Default 87 Chevy Pickup 350 EFI "Blown ECM Fuse"


There is still a chance that the fuel pump is going bad and the extra
draw from it shorted out ECM output and caused its failure. Those
pumps have a fairly high failure rate if you are one to run them low
on fuel a lot.
-----------------
TheSnoMan.com
  Reply With Quote
3 13th August 18:36
ricks87chevy
External User
 
Posts: 1
Default 87 Chevy Pickup 350 EFI "Blown ECM Fuse"


Hmm ok, we'll have to check on that then. Also, since replacing the ECM, when
cranking, the check engine light comes on, blinks off once and then comes
back on and stays on?
  Reply With Quote
4 13th August 18:37
snoman
External User
 
Posts: 1
Default 87 Chevy Pickup 350 EFI "Blown ECM Fuse"


A code is being set in ECM. Have you tried to read it!
-----------------
TheSnoMan.com
  Reply With Quote
5 14th August 09:50
stormin mormon
External User
 
Posts: 1
Default 87 Chevy Pickup fuel pump failure


As I understand, the gasoline cools the pump. So low fuel
oveheats the pump. Try to keep at least half a tank.

--

Christopher A. Young
You can't shout down a troll.
You have to starve them.
..

: >truck STILL won't start!!!! Now what??? ANY advice or suggestions, welcome!
: >Thanks,
:
:
: There is still a chance that the fuel pump is going bad and the
extra
: draw from it shorted out ECM output and caused its failure.
Those
: pumps have a fairly high failure rate if you are one to run
them low
: on fuel a lot.
: -----------------
: TheSnoMan.com
  Reply With Quote
Reply


Thread Tools
Display Modes




Copyright 2006 SmartyDevil.com - Dies Mies Jeschet Boenedoesef Douvema Enitemaus -
666