//zigge 2011-01-16 14:33:53
I have just replaced the front right ABS sensor on my S10 4×4 (1994) and now
the ABS light is on all the time.
I suspect that the foult is a confused ABS computer, how do I reset it?
Other suggest are wellcome 🙂
Bobo 2011-01-16 14:34:02
the light will go out if the fault is removed…. check codes again and see
what is setting
//zigge 2011-01-16 14:34:16
I’m sorry to say so, but I’m a total newbee at this. I replaced the sensor
when the wires was ripped of… so I dont know how to make the manual
I have read on the internet, that I can put a jumper wire between pin A and
H on the diagnostics connector.. and so on and so forth…
Now its 2 am in the morning here (Denmark). Are the pins clearly marked or
do I need a pinout to find the right pins? (and if so I would really like a
pinout 🙂 and where is the connector located?
\doc\ 2011-01-16 14:34:30
Here’s what you need:
//zigge 2011-01-16 22:05:23
Magnificent, just the medicine 😉
//zigge 2011-01-16 22:08:20
And tanx a million for all the support. The computer has been reset now, and
everything works fine.
Bobo 2011-01-17 05:52:15
I hope you don’t mind me asking, but what did you reset????? clear the codes
Scott m 2011-01-17 05:52:41
Bobo, after working on a car s******* with the ABS, air bag or ECM – havent
you ever had that feeling that you need to take it’s power away for a while
because the stupid thing is just acting goofy? Then after doing so, it just
seemed to fix itself…..?
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.547 / Virus Database: 340 – Release Date: 12/2/2003