wicket187

I have a 1996 dodge caravan with a 3.0 v6, and I’m having quite a
problem. We just put a transmission in it, and now when we start it,
when you put it in any gear the vehicle dies. There are also no
trouble codes. Does anyone know what I sould look at, could it be the
TCM,PCM, or any of the other sensors.

--
Posted at author's request, using http://www.AutoBoardz.com interface
Articles individually verified to usenet standards. Visit URL to contact author/report abuse
Thread archive: http://www.AutoBoardz.com/1996-caravan-help-ftopict204755.html

maxpower

We put it in as in you did? If this vehicle has a crank sensor on it you may
have damaged the sensor or did not install it and get the right air gap for
it to work right.

Glenn Beasley
Chrysler Tech

tlc1196

Just curious, why would the crank sensor let it run until put in drive?

How about a locking converter not unlocking?

maxpower

Improper air gap. The reason why I said that is because I see this happen so
many times after a trans has been taken out. Normally the person installs
the crank sensor without installing the paper shim on the sensor and then
crank sensor gets damaged.
But yes, you are also right, a Torque converter that is not releasing could
also cause this. A dirty throttle body could cause it too.
The op would actually have to have a scan tool connected to see what the
inputs and outputs of the trans and engine controller.

Glenn