Mombu 2011-01-13 16:43:25
Where is the crank position sensor located on a 1997 Chysler LHS with
a 3.5 liter engine. My car has been jerking, spitting , and having duck
since Sunday afternoon. I recieve a code 11 when I did the self test
using the ign. switch. I change the cam sensor on today and it seemed
to run somewhat better, but by the time I left my house and drove about
2 miles to work it stalled in the parking lot. I tried to restart it,
but it will not start. I think it’s the crankshaft sensor, but I am not
for sure. Can anyone help. If I can located it, I will change it and
see if this is really the problem.
Maxpower 2011-01-13 16:43:27
Mounted on the passenger side engine block next to the transmission.
Mombu 2011-01-13 16:43:32
Thanks a million
Mombu 2011-01-13 16:43:34
Thanks a million
Maxpower 2011-01-13 16:43:36
That was 2 million!
Mombu 2011-01-13 16:43:38
The info was worth it. I hope it works.
Maxpower 2011-01-13 16:43:40
Make sure when you put the sensor in the hole you press firmly on it while
tightening the bolt. There should be a piece of paper stuck to the sensor.
That is to get the correct air gap…..don’t pull it off
Mombu 2011-01-13 16:43:55
Well , I replace the sensor and the car still will not start. There was
no paper stuck to the sensor, should there have been. Would this cause
the car not to start. I am at my wits end. I have to be in Pittsburgh
on Friday morning. It’s a twelve hour drive from where I live. Thinking
about a rental, but didn’t want to take that route.
Damnnickname 2011-01-13 16:44:01
Im at worked and just checked on that, I stand corrected, there is no shim
on that sensor for that year.
Your probably gonna have to have someone monitor the engine controller
with a scan tool to see what is going on.
A fuel pressure test would be a good idea now also.