Mombu the Ford Forum sponsored links

Go Back   Mombu the Ford Forum > Ford > 1994 ford taurus idle problems
User Name
Password
REGISTER NOW! Mark Forums Read

sponsored links


Reply
 
1 31st May 04:30
g.w.
External User
 
Posts: 1
Default 1994 ford taurus idle problems


I recently had a no start in this vehicle. here's what been done Lots of
parts some were bad some were questionable at times the car would let you
pull codes first thing in the morning only once then you couldn't access
codes again till car sat for awhile even had a mechanic try hooking up his
snap on scan and he couldn't connect to the computer.
1) ignition module( last time three years ago this was problem)
2) cap & rotor
3) pick up coil in dist.
4) spark plugs (first set fouled out)
5) relay module on rad. ( fan and fuel pump ran constant)
6) fuel filter (fuel pressure 30 psi when running 40 psi on acc.)
7) coolant temp switch (questionable )
8) act switch ( burnt and carbon fouled)
9) oil sending unit (leaking)
10) maf sensor ( seemed reasonable 149,000 mile on old one)
11) tps ( open no res. between post when off car)
12) Iac motor ( frozen cone and shaft even tried cleaning ng)
13) eec computer ( last component replaced car started up runs good fan and
fuel pump run like there suppose too fuel two sec shuts off fan up to temp.
then runs)
Car now runs idles high, yes I did mess with idle screw during attempt to
get vehicle running when it would idle poorly used a tank of gas just idling
in driveway. It seems the computer was shoot from the beginning but now all
new parts. why would engine idle faster than it should. Book says eec
controls idle. with all new parts where should I look or do next. checked al
vacuum lines replaced cracked or bad looking lines so no vac leak egr valve
moves removed and cleaned applied vac can hear valve open and close. Cleaned
throttle body scan codes are 536 and 538 .
  Reply With Quote


  sponsored links


2 31st May 04:30
backyard mechanic
External User
 
Posts: 1
Default 1994 ford taurus idle problems


First the codes arent significant... they are KOER test, and probably
there because you didnt goose it or push brake at proper time

AssuMe the ENTIRE IAC is new?

With IAC plug disconnected, still idles high?

With all manifold vacuum ports, except port for Fuel Press Reg, disc and
plugged?

If idle still high..(assuming you tried to return stop screw to orig pos)
then are you sure throttle plate isnt binding, somehow?

--
Yeh, I'm a Krusty old Geezer, putting up with my 'smartass' is the price
you pay..DEAL with it!
  Reply With Quote


  sponsored links


3 31st May 04:30
External User
 
Posts: 1
Default 1994 ford taurus idle problems


Seems to me that you still missed several places where vacuum could be
leaking. It's not just vacuum hoses and fittings that can leak, but
anything that uses vacuum can leak. The best way to check everything
is with a vacuum pump that has a gauge, such as the MityVac. The EGR
valve is a good start, but you can get a high idle if the EFE solenoid
is leaking (partially stuck open), there is that other vacuum line that
goes into the dash and is used for a HVAC flapper. Plus it could be
the power brake booster or cruise control.
  Reply With Quote
4 31st May 04:30
johanb
External User
 
Posts: 1
Default 1994 ford taurus idle problems


Howbout a squirt bottle with water and spray everything thats vacuum related

The water will fill up the leak/crack for a second and will make the idle
change
  Reply With Quote
5 31st May 04:31
ted
External User
 
Posts: 1
Default 1994 ford taurus idle problems


Water will not seal a vacuum leak at all- where did you get this nonsense?
The water will simply be drawn into the combustion chamber, just like water
through a straw;
Use a propane leak detection device instead. This is a tool specifically
designed to release a small amount of propane gas through a hose that can be
directed to the potential leak source. This artificial enrichment will show
an immediate reaction to the idle when a leak is found. And yes, it is
safe; the proper tool will not put out enough gas to be any kind of hazard.
  Reply With Quote
6 31st May 18:53
johanb
External User
 
Posts: 1
Default 1994 ford taurus idle problems


It will for a brief moment wich is enough to find a small vacuum leak, been
doing it for years

if the leak is as big as the hole in a straw you dont need a squirt bottle
but you need your eyes and ears checked


not every D.I.Y here has a propane leak device, a squirt bottle will do,
unless you want to take your bbq apart and haul the bottle around
Also a can of carb or t-body cleaner will work ,but again, not all people
have that in there garage sitting on a shelf

hazard.
  Reply With Quote
Reply


Thread Tools
Display Modes




Copyright 2006 SmartyDevil.com - Dies Mies Jeschet Boenedoesef Douvema Enitemaus -
666