X-No-Archive: Yes

Hello,

I had factory steel wheels and factory tires on my Focus and I recently
got a set of used OEM 16" alloy wheels and a set of new Fuzion tires
and now I'm getting a vibration like the wheels needs balancing.
Vibration appeared right after the new setup.

Vibration becomes bothersome between 60-80 mph, but between 60-65 seems
to be the resonance point. In the daylight, I could see the steering
wheel vibrating at a relatively high frequency.

Having had done these, I'm not sure else I can do.

1. Wheels are OEM Ford from a different trim of the same model and
they're hub-centric.

2. Spin balanced all four wheels, three times. Both readings are below
1/4oz for all four wheels.

3. ForceMatch and Road Force balanced on Hunter GSP9700. ForceMatched
to <15 lbs. All wheels passed the test for wheel runouts in both
radial and lateral.

4. Wheel bearings: No noticeable play.

Any idea what else?

lsrx101

I don't know much about "Force Matching" and "Road Force Balancing" and
have considered them gimmicks until I learn that they are viable. I do
know that you can't balance an egg. If a tire is out of round. it will
ALWAYS vibrate. The amount of runout becomes more critical at higher
speeds. At 80 mph, they need to be checked with a dial indicator. It's
unreasonable to expect them to be perfectly smooth up through 80 mph,
IMHO. The used wheels are another variable. At taose speeds, micrometer
readings of runout may give you an idea of the problem.

X-No-Archive: Yes

Hunter GSP9700 applies a pressure on the tire with a roller, then
measure the variation in force between the axle and the road surface
(simulated by the roller). If it was out of round, it would detect it.

walt peifer

As I deal with mostly older fords I will relate this, I sell the older style
magnum and styled wheels. I don't believe in the road force approach to
wheel balancing.
I have had several sets of wheels that check as out of round on the new
machines ( cars had a vibration), took one the car to another old time tire
dealer. the mechanic stripped the wheel weights and then used and old
fashioned bubble balancer, to rebalance the wheels. he simply split the
value of weight needed between the front and rear of the wheel, no more
vibration! Now I send all of wheel customers to him and no problem since.

mike romain

I don't think so.....

I would highly recommend you just jack up one tire at a time and spin it
by hand while watching it or using a stick between the tire and ground
to see if it is round.

Putting pressure on it with a roller sure won't pick this up.

These 'technicians' these days only use computers to tell then what is
wrong, they forget what their eyes are for.

Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pictures.html?id=2115147590
(More Off Road album links at bottom of the view page)