bootitng and raid

Does anyone have experience with bootitng and raid?

I boot to bootitng on the ide master - there's also a slave.

bootitng is not recognizing the newly made serial striped ata raid on my
Gigabyte K8NS-939 nforce 3 ultra, and hides the ide slave until I turn off
the raid. Then it sees the 2 serial drives ok.

I'm wondering if it's just because of that particular motherboard, or if it
needs a full hardware raid to see the array.

If it needs hardware raid, what would be the cheapest?

--
Ed Light

Smiley :-/
MS Smiley :-\

Send spam to the FTC at
uce@ftc.gov
Thanks, robots.

The trick is that the storage needs to be presented as LUN 0

I thought I was pretty educated -- but what's that?

Thanks.

--
Ed Light

Smiley :-/
MS Smiley :-\

Send spam to the FTC at
uce@ftc.gov
Thanks, robots.

you need to install the nVidia driver(s) using F6 during setup. This is
tricky with nVidia because you have to load two drivers and F6 only picks up
one driver at a time. Contact them for more information.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode test 33Switch to Hybrid Mode Switch to Threaded Mode

2 25th July 05:36 exchange storage guy External User Posts: 1	bootitng and raid The trick is that the storage needs to be presented as LUN 0

3 25th July 05:37 ed light External User Posts: 1	bootitng and raid I thought I was pretty educated -- but what's that? Thanks. -- Ed Light Smiley :-/ MS Smiley :-\ Send spam to the FTC at uce@ftc.gov Thanks, robots.

4 2nd August 04:54 jeff goldner [ms] External User Posts: 1	bootitng and raid you need to install the nVidia driver(s) using F6 during setup. This is tricky with nVidia because you have to load two drivers and F6 only picks up one driver at a time. Contact them for more information.